Vestil LAD-MM User Manual

INSTRUCTION MANUAL MOBILE LADDER STAND LAD-MM MODEL NO. ________________________ SERIAL NO. ________________________ VESTIL MANUFACTURING CORP. 2

4Outside Edge2-1/4inch Bolt Inside Edge 5/16in. Lock Nut Instruction 4: Attach the step weldment (1) to the back leg weldment (2) with 1-1/2in. bol

Base Support5/16in. Lock Nut 34 Instruction 6: Connect the other end of the base support to the step frame bracket with a 3/4in. bolt (B). Tighte

- 12 - Inner edge of platform handrail bracket 4 1-1/2in. Bolt5 3Inner edge5/16in. Lock Nut67 Instruction 11: Install th

To avoid the potential for serious personal injury, always adhere to the following practices: • Ladders should not be used as a brace, skid, guy or

4. Ascend the ladder by facing the steps and using both handrails. The ladder is designed to support a combined weight of 350 pounds. Before liftin

by pulling on the bolt head and attempting to rotate the bolt. Tighten any loosened lock nuts with a pair of 5/16in. crescent wrenches. Employers

- 16 -FIG. 3: Safety Label Placement ANSI A14.7-2006 Chapter 7, p. 12.

Serial No. __________________ Model: ____________________Serial No. __________________ Model: ____________________ Enter information after re

We produce several models of ladder stand so that our customers may select a product that satisfies specific requirements. The products identified o

- 3 -TABLE OF CONTENTS Safety Principles 2 Product Introduction 4 Safety Guidelines 5 Receipt & Assembly Instructions

PRODUCT INTRODUCTION - 4 - Thank you for purchasing a mobile ladder stand made by Vestil Manufacturing Corporation (“Vestil

SAFETY GUIDELINES Read the entire manual before you assemble the ladder stand or use it for the first time; refer to it for manufacturer-approved saf

FIG. 1: LAD-MM 2ft. safety chain Handrail Handrail Brackets 1 inch D-ring Handrail Brackets Back Leg Angled SupportBase supports Back Leg Horizon

FIG. 2: LADDER STEP SURFACES P (Perforated) G (Grip-Strut

LAD-MM Parts List 1 2 3 A (actual size) B (actual size) C (actual size) D (actual size) E F G H I Id Symbol Replace

Instruction 1: Install a plastic plug (I) into each front leg of the step weldment (1) as shown in the photographs below. The front legs are circled