Vestil LAD-RF User Manual

INSTRUCTION MANUAL MOBILE LADDER STAND LAD-RF MODEL NO. ________________________ SERIAL NO. ________________________ VESTIL MANUFACTURING CORP.

Instruction 4: Insert the axle into the axle-receiving opening of the back leg weldment as shown. A few inches of the axle should protrude from the o

Instruction 7: Rotate the free ends of the horizontal braces until they are parallel to the back legs. Secure the braces to the legs using the self-f

Instruction 10: Rotate the ladder so that it rests on one side; then rotate the back leg assembly away from the step weldment as shown in photos 1-8 b

The braces can be attached to either the inside or outside of the step frame brackets. Photos 5 and 6 demonstrate attachment to the outer side of a

Store the 3/4in bolts and corresponding lock nuts someplace where you will be able to find them when the ladder is needed again. You shoul

Although ladders are simple mechanisms, improper use can result in serious injuries. OSHA regulation 1910.26(c)(2)(vi) requires immediate inspec

Maintenance Procedures: Proper maintenance is an essential responsibility of the ladder owner and end-user. Failure to adopt and implement regular

17FIG. 3: Safety Label Placement ANSI A14.7-2006 Chapter 7, p. 12.

Serial No. __________________ Model: ____________________Serial No. __________________ Model: ____________________ Enter information after re

We produce several models of ladder stand so that our customers may select a product that satisfies specific requirements. The products identified

- 3 -TABLE OF CONTENTS Safety Principles 2 Product Introduction 4 Safety Guidelines 5 Product Assembly 7 -13 Safety

PRODUCT INTRODUCTION 4 Thank you for purchasing a mobile ladder stand made by Vestil Manufacturing Corporation (“Vestil”).

SAFETY GUIDELINES Read the entire manual before you assemble the ladder stand or use it for the first time; refer to it for manufacturer-approved saf

FIG. 1A: LAD-RF 6 Handrail support tube Top Platform Back Leg Weldment 10 Inch Semi-pneumatic wheel Step FIG.

FIG. 2: LADDER STEP SURFACES P (Perforated) G (Grip-Strut

LAD-RF Parts List 1 2 3 (Editing in progress) 5 PLATFORM Axle End Bolt End 6 7 A (actual size) B (actual size) C (a

Instruction 1: Position the step weldment (1) face down. Install a plastic plug (F) into each front leg of the step weldment (1) as shown in the photo