Vestil CB-W-2P User Manual download pdf

Vestil Manufacturing Corporation

2999 North Wayne St., Angola, IN 46703

Ph: 260-665-7586 • Fax: 260-665-1339

E-mail: [email protected]

Website: www.vestil.com

Contents

GAS CYLINDER POLY BUMPER

OWNER'S

MANUAL

Revised 08-04

A company dedicated to solving ergonomic

and material handling problems since 1955.

Ergonomic Solutions

RECEIVING INSTRUCTIONS

Every unit is thoroughly tested and inspected prior to shipment.

However, it is possible that the unit may incur damage during

transit. If damage is noticed when unloading, make a note of it

on the BILL OF LADING. Remove all packing and strapping

material, then inspect the unit again for damage. IF DAMAGE IS

EVIDENT, FILE A CLAIM WITH THE FREIGHT CARRIER

IMMEDIATELY!

WARRANTY

This product is warranted for 90 DAYS from date of purchase to

be free of manufacturing defects in material and workmanship.

This warranty does not cover normal wear of parts or damage

resulting from any of the following: negligent use or misuse of

the product, use or application contrary to installation

instructions, or disassembly, repair or alteration by any person

prior to authorization from a factory representative.

INCLUDED

(1) Poly Bumper

(1) Heavy Duty Nylon Strap Assembly

**NOTE**

Hardware used to mount your bumper bracket to the wall is not

included. Your mounting surface will determine the hardware

used for installation.

MOUNTING RECOMMENDATIONS

• CONCRETE WALL: (2) 3/8" diameter x 3-1/2" long lag screws

with masonry expansion shieds

• WOOD WALL: (2) 3/8" diameter x 3-1/2" long wood screws

• CINDER BLOCK WALL: (2) 3/8" diameter x 3-1/2" long lag

screws with masonry expansion shieds.

• DRY WALL: (2) 3/8" diameter x 4-1/2" long t-style hollow wall

anchors.

Drywall material recommendation is listed above, but it is not

advisable due to lack of surface strength unless anchored to a stud.

Receiving Instructions .......................................... 1

Warranty ............................................................... 1

Mounting Recommendations.................................1

Mounting Instructions ............................................1

MOUNTING INSTRUCTIONS:

1) Feed a washer onto the screw or

bolt you supply, then feed one half

of the strap assembly onto that

same screw or bolt. Make sure that

the show side of the buckle faces

you.

2) Follow step one for the other side

of the strap assembly.

3) For best stability results, mount

your poly bumper approximately

2/3 up from the floor using the

average height of your most

commonly used gas cylinder.

4) Push each bolt through their

respective holes on the poly

bumper bracket. Then

proceed to anchor to the wall.

AVERAGE

HEIGHT

2/3 HEIGHT

OF AVERAGE

CYLINDER

OWNER'S 1

Summary of Contents

Page 1 - OWNER'S

Vestil Manufacturing Corporation2999 North Wayne St., Angola, IN 46703Ph: 260-665-7586 • Fax: 260-665-1339E-mail: [email protected]: www.vestil.

Related models: CB-W-P

Comments to this Manuals

No comments

Vestil CB-W-2P User Manual

Browse online or download User Manual for Equipment Vestil CB-W-2P. Vestil CB-W-2P User Manual [en]

Summary of Contents

Related models: CB-W-P

Comments to this Manuals

Related products and manuals for Equipment Vestil CB-W-2P