Vestil GLT-4000 User Manual

1Vestil Manufacturing Corporation2999 North Wayne St., Angola, IN 46703Phone (260) 665-7586 • Fax (260) 665-1339E-mail: [email protected] • www.ves

10PARTS IDENTIFICATIONGROUND TILTER • GLT-4000DESCRIPTIONClevis Pin 1 x 3-1/4Cylinder 2 x 8Hair Pin ClipClevis Pin 1 x 2-1/4Right Side GuardScrew 5-1/

11HYDRAULIC EQUIPMENTTrouble Shooting Quick Reference Guide(For further information contact the factory)WARNING! BEFORE PERFORMING ANY MAINTENANCE WOR

12Observation Possible Cause Remedy5.) Table lowers too slowly when loaded.6.) Table lowers too quickly.7. Table raises then lowers slowly.8. Table ha

13WARNING LABEL IDENTIFICATIONMAKE SURE ALL WARNING LABELS ARE IN PLACE!37342*Product safety signs or labels should beperiodically inspected and clean

14MATERIAL SAFETY DATA SHEETRequired under USDL Safety and Health Regulations for Ship Repairing,Shipbuilding, and Shipbreaking (29 CFR 1915, 1916, 19

15SECTION V - HEALTH HAZARD DATATHRESHHOLD LIMIT VALUE8 Hr. time weighted pemissible exposure 5.0 mg/m3 as oil mistEFFECTS OF OVEREXPOSUREEYE: may cau

16DATE OF SERVICE:_____/_____/_____WORK DONE BY:______________________________SERVICE PERFORMED:______________________________________________________

2INSTALLATION INSTRUCTIONSReview Complete Owner's Manual BeforeCommencing Installation.For installation you will need the following:1.) A fork tr

3PERIODIC MAINTENANCE INSTRUCTIONSWARNING! BEFORE PERFORMING ANY MAINTENANCE WORK ALWAYS UNLOAD LIFT AND INSTALL MAINTENANCE SAFETY STOP(S)(A) Before

4ELECTRICAL SCHEMATIC

5MOTOR VOLTAGE CONVERSION

6PRIMARY WIRING FOR CONTROL TRANSFORMER

7HYDRAULIC OPERATIONWhen the operator wants to raise the unit, he depresses the UP button. This starts the electricmotor (Item 3) which turns the hydr

8AIR BLEED PROCEDUREIf your unit descends very slowly or will not descend at all, air could be trapped in the hydraulic circuitand must be "bled&

9EXPLODED PARTS DRAWINGGROUND TILTER • GLT-40001389101114, 1576341563211216